Digital Terrestrial: it is no longer possible to see

DVB-T2, that new generation digital terrestrial which is about to become an inseparable companion of our TV, is now upon us. A few definitive steps are still missing, then the revolution should be completed between the end of 2022 and the beginning of 2023.

It should, conditionally obligatory, given that there are still problems resulting from the switch-off of 8 March, when RAI And Mediaset they switched to the new encoding, for a short while with the new-old double chance.

DVB-T2 – Adobe Stock

Both with the advent MPEG-4 (for everyone) and after the completion of the refarming last June 2022, with the release of the 700MHz frequencies for the new Sub 700MHz frequencies, the transition was not painless for everyone.

An indoor digital antenna amplifier, with LTE filter

Many are continuing to have trouble with the definitive transition to DVB-T2, in some cases the most recurring problems come from the interference of our smartphones, both Android and iOS, maybe one of the two was the problem.

It is a matter of interference, specifically between network technology LTE own cell phones and the incoming signal to the TV tuner. The solution is in a device that is close to thirty euros, which can be purchased directly on Amazon

Digital Terrestrial 20220822 cell
Digital Terrestrial – Adobe Stock

Many are continuing to have trouble with the definitive transition to DVB-T2, in some cases the most recurring problems come from the interference of our smartphones, both Android and iOS, maybe one of the two was the problem.

It is a matter of interference, specifically between network technology LTE own cell phones and the incoming signal to the TV tuner. The solution is in a device that is close to thirty euros, which can be purchased directly on Amazon.

There are many, spoiled for choice, but one of those that solved the problem of interference is the Meliconi AMP20, an indoor digital antenna amplifier, with LTE filter. So many advantages and just as many satisfactions.

The device amplifies the signals more than 10 times compared to the standard, improves the quality in the event of a signal that is too weak at the input, or of disturbances due to excessive length of the connections. Not only.

It is also ideal for distributing the amplified signal to two separate devices, easy to install and ready to use. Direct feed a 220V. And a trick.

For correct operation, in fact, a clean input signal is required, with little noise and an adequate level. Only in this way will his performances be enhanced. In typical situations, with a weak but clean signal, the product works very well. Finally, sometimes the different channels have different amplitudes and the setting of the AMP20 must be decreased in order not to saturate the TV tuner.

L’AMP 20 Meliconi it is used to amplify a good quality TV signal before a long extension cable or to split a good quality TV signal on two devices. 7 x 11.5 x 11.3 cm its dimensions, small and not bulky. Forty grams its weight.

If this does not work either, calling a technician must be mandatory, as the problem is much more serious than it appears.

Leave a Comment

Your email address will not be published.